Hello, for some time now I've had an issue where as the printer homes everything and prepares for the print, most of the time one of the homes fails. More often then not it is the x-axis. When I have all heaters off everything homes fine usually. As I start a print and it homes to the x-axis it will simply just freeze in the position and stop. My s3d communication log then just spams the lines below. Other times it will be the y-axis that fails and occasionally the Z. I tried a different power supply thinking it wasn't getting enough amps, no dice. Also Tried switching to a faster USB Port. The fourth scenario of me starting a print is that my thermistor will read 500 and my printer will run to dry mode. Any ideas would be greatly appreciated.
RECEIVED: start
RECEIVED: Transformation matrix: 1.000000 0.000000 0.000000 0.000000 1.000000 0.000000 0.000000 0.000000 1.000000
RECEIVED: Free RAM:4069
RECEIVED: FlowMultiply:100
RECEIVED: wait
RECEIVED: wait
RECEIVED: wait
RECEIVED: wait
RECEIVED: wait
RECEIVED: wait
RECEIVED: wait
RECEIVED: wait
RECEIVED: wait