Hi to all,
i'm new about printing and i've buyed a Prusa I3X from GEETech.
The first issue i have had is that the X axis (using Repetitier host) when trying to search home position (X_MIN) was going in the wrong site (my limit switch was to left.... and "she" going to the right...)
So i've downloaded the lastest Marlin firmware and i've just setup my board (Ultimaker) the fact that i have temperature control for bed and extruder and activated the LCD support.
X_MAX_POS is set to 205 (i guess mean 20,5 CM), Y_MAX_POS is 205 too and Z_MAX_POS is 200.
All the rest is default Configuration.h from Marlin.
Now, when i connect to repetitier host and i hit "Search Home", the printer move only to one step and immediatly stop. This happen to all three axis (X, Y, and Z).
The same happen when i do "Autohome" from LCD control.
Someone have some idea to what is wrong ?
Edited 1 time(s). Last edit at 09/27/2015 10:39AM by mistre83.