wilson ts - home issue

hello,

this might be very simple issue for some. when I tried home button, x moves toward endstop veryyyy slowly and y moves away from endstop! also very slowly at which point I pulled the powe plug because I know the bed will crash.

how can I increase some speed? and also why is my y home moves away from end stop? I check on pronterface that y direction is correct (bigger number, moves into the page.)

thanks,

Well, it turns out homing feedrate was 200 mm/min.... Change it to 1200 mm/min and speed is good now.

I also switched the y motor connector at the board.
Still having issue with z motor homing. Both would stall and the shaft also appear to be jerking back and forth