Hello,
I tried yesterday to print a test piece with my just finished i3 rework, but it seems that i had got a clog, i successfully remove it with a bath of acetone.
Now i just retried the print but it seems that no plastic goes out of my hotend
I removed the filament without problem or resistance, so i am sure it's not a clog because the filament is not clogged (it seems so)
I checked if it was not a jam, and i am pretty sure it is not a jam.
What could it be ?
I printed esun abs
Hotend temp: 225°C
Heatbed temp: 100°C
Thanks in advance