Welcome! Log In Create A New Profile

Prusa i3 Resizing Possible?

Posted by Berke2

Berke2

Prusa i3 Resizing Possible?
June 29, 2015 01:33PM

Registered: 8 years ago
Posts: 2

You know the work place for i3 is 20x20x20 cm. I was wondering, if i bought a kit, then resized the mill and other needed parts so i could have a 50x50x50 cm work place. Would that be possible and would it work? I dont really know much about Arduino so would it be possible to configure it to that size? If so could you explain how? Thank you for your answers.

Reply Quote

Plasteroid

Re: Prusa i3 Resizing Possible?
June 29, 2015 02:47PM

Registered: 9 years ago
Posts: 125

Check this: Prusa Titan

It's near 40x40cm I think.

Prusa i3, Ramps 1.4. Catnozzle 0.4mm
SketchUp - Enveloping Globoid Worm Gear - Part One - 3D Printed: [youtu.be]
DesignSpark Mechanical & more precise screw thread: [youtu.be]
Nicer Screw Thread In SketchUp ( Bolts,Nuts): [youtu.be]
How To Model A Heart Shape In SketchUp: [youtu.be]
How To Draw 3D Printable Snap Fit Ball Joint In SketchUp: [youtu.be]

Reply Quote

Berke2

Re: Prusa i3 Resizing Possible?
June 29, 2015 02:52PM

Registered: 8 years ago
Posts: 2

Is there a place I can buy it tho? Because i checked this before and couldn't find it.