Prusa i3 stops when hitting end stop, motors respond not well June 27, 2015 05:00PM |
Registered: 8 years ago Posts: 1 |
Connecting... start Printer is now online. echo: External Reset Marlin 1.0.0 echo: Last Updated: Jun 26 2015 22:10:56 | Author: (none, default config) Compiled: Jun 26 2015 echo: Free Memory: 4103 PlannerBufferBytes: 1232 echo:Hardcoded Default Settings Loaded echoteps per unit: echo: M92 X157.48 Y157.48 Z5120.00 E1140.00 echo:Maximum feedrates (mm/s): echo: M203 X1000.00 Y1000.00 Z500.00 E500.00 echo:Maximum Acceleration (mm/s2): echo: M201 X9000 Y9000 Z100 E10000 echo:Acceleration: S=acceleration, T=retract acceleration echo: M204 S3000.00 T3000.00 echo:Advanced variables: S=Min feedrate (mm/s), T=Min travel feedrate (mm/s), B=minimum segment time (ms), X=maximum XY jerk (mm/s), Z=maximum Z jerk (mm/s), E=maximum E jerk (mm/s) echo: M205 S0.00 T0.00 B20000 X20.00 Z0.40 E5.00 echo:Home offset (mm): echo: M206 X0.00 Y0.00 Z0.00 echoID settings: echo: M301 P22.20 I1.08 D114.00 echoD init fail [ERROR] Can't read from printer (disconnected?) (SerialException): call to ClearCommError failed [ERROR] Can't write to printer (disconnected?) (SerialException): WriteFile failed ([Error 5] Access is denied.) [ERROR] Can't write to printer (disconnected?) (SerialException): WriteFile failed ([Error 5] Access is denied.) [ERROR] Can't write to printer (disconnected?) (SerialException): WriteFile failed ([Error 5] Access is denied.) [ERROR] Can't write to printer (disconnected?) (SerialException): WriteFile failed ([Error 5] Access is denied.) [ERROR] Can't write to printer (disconnected?) (SerialException): WriteFile failed ([Error 5] Access is denied.) [ERROR] Disconnecting after 4 failed writes. Disconnected.
Re: Prusa i3 stops when hitting end stop, motors respond not well June 28, 2015 03:09AM |
Registered: 8 years ago Posts: 5,232 |