Hi there, dear community.
My printer has suddenly developed a strange problem thats puzzling me and I think I for once are giving up a little..
Here my setup
Prusa I3
Arduino/ramps/marlin
Autoleveling with servo assisted probe
Safe homing enabled
It took a while to get it running smoothly but it has been working fine for sometime until now. Suddenly, when homing Z axis, the Y axis runs to fast to far. It reaches end of travel long before Z axis reaches homing position in the center of the build table. Before, it always stopped nicely in the middle, let the probe down and homed Z.
I can't for my life understand why it does this! I checked all cables changed y axis stepper driver and even reflashed mailn but no luck.
I'm at my wits en here. Any ideas?