Welcome! Log In Create A New Profile

Mini_IR Z-probe pcb drawing?

Posted by o_lampe

o_lampe

Mini_IR Z-probe pcb drawing?
April 24, 2018 04:00AM

Registered: 8 years ago
Posts: 5,232

I have to make a custom bracket to mount dc42's mini_IR Z-probe under my Delrin ball effector. I've found the distance between the mounting holes is 18.4mm, but what I'm looking for is the distance from PCB-bottom edge to center of mounting hole.

Thanks in advance
Olaf

Reply Quote

dc42

Re: Mini_IR Z-probe pcb drawing?
April 24, 2018 02:18PM

Registered: 10 years ago
Posts: 14,672

I don't have a drawing, but at [miscsolutions.wordpress.com] you will find the following in the Appendix:

Quote

If the bottom left corner of the board is position (0, 0) then other points on the board are at the following (X, Y) coordinates, in mm:

Top right corner (24.0, 17.62)
Mounting hole centres (2.70, 14.92) and (21.11, 14.92)
Mounting hole diameter 2.8

Edited 1 time(s). Last edit at 04/24/2018 02:18PM by dc42.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].