Welcome! Log In Create A New Profile

Advanced

Prints going through bed instead of upwards?

Posted by BARRIE_K 
Prints going through bed instead of upwards?
July 21, 2017 04:14AM
Can anyone help? Hotend prints bed tries to go through the bed instead of upwards. Fillament feeds fine, everything homes correctly even with induction sensor. G28 and G29 work fine just when I try and print.

Anyone ANY ideas?
Re: Prints going through bed instead of upwards?
July 21, 2017 05:57AM
So after homing Z, if you send a g-code
G1 Z5

does the nozzle move up to Z5 ?
Do you have a -Z offset entered in the slicer ?

post the 1st 20 lines of your g code you are trying to print
Sorry, only registered users may post in this forum.

Click here to login