Hello There,
I am new to the 3D printing scene and I just finished up building my Reprap Prusa i3. I have been printing a few things out but I've noticed that my prints are a little sloppy. I have adjusted a few settings but I am not quite sure what needs to be adjusted to get a solid and smooth 3D print. There are a lot of jagged ends and the object is not at all solid or smooth.
I am looking to get an object as smooth as possible. So far I have been adjusting Layer hight, infill density, infill pattern, and solid infill pattern.
I have attached links of a boat I printed out for reference. Any suggestions would be much appreciated.
[
drive.google.com]
[
drive.google.com]
[
drive.google.com]