Welcome! Log In Create A New Profile

Prusa Single Frame - Heated bed screw touching frame

Posted by brunoip

brunoip

Prusa Single Frame - Heated bed screw touching frame
April 06, 2017 11:23AM

Registered: 7 years ago
Posts: 2

Hi, I have just finished assembling my printer but I found a problem. The screws used for holding the heated bed in position touch the frame when they move forward and the bed is not able to reach the final position. Did I made something wrong or I have the wrong model of frame for this bed?
Regards, Bruno.

oek9b5O.jpg

Reply Quote

the_digital_dentist

Re: Prusa Single Frame - Heated bed screw touching frame
April 06, 2017 11:33AM

Registered: 11 years ago
Posts: 5,780

Your guide rails are probably not orthogonal. They should all be perpendicular to each other. If they aren't you will have this type of problem.

Ultra MegaMax Dominator 3D printer: [drmrehorst.blogspot.com]

Reply Quote

Floyd

Re: Prusa Single Frame - Heated bed screw touching frame
April 06, 2017 03:01PM

Registered: 10 years ago
Posts: 770

If everything is squared and still hits just file that edge off to make it work.
I had to do the same thing to my kit.

Reply Quote

o_lampe

Re: Prusa Single Frame - Heated bed screw touching frame
April 07, 2017 03:16AM

Registered: 8 years ago
Posts: 5,232

[OT]
IMHO you tightened the springs too much that hold the heatbed.

If you file down the frame, make enough room for a nyloc nut to pass. That will help you to level the bed.

Reply Quote

brunoip

Re: Prusa Single Frame - Heated bed screw touching frame
April 08, 2017 07:01PM

Registered: 7 years ago
Posts: 2

I cut a lot of the frame and now it works perfect, thanks.

vXTYwXP.jpg