endstops are not working
Posted by rohit939
|
endstops are not working April 02, 2017 08:37AM |
i'm using marlin firmware and ramps 1.4
stepper motors are working as usual but whenever i click home x on repitier host the motor turns in forward direction not reverse, and motor does not turn complete it takes on 5-10mm steps. dont know what is wrong with it
any help will be highly appreciated and i'm new to this
i'm using these endstops
[www.amazon.in]
Got them working. deleting it.
Edited 3 time(s). Last edit at 04/02/2017 10:11AM by rohit939.
stepper motors are working as usual but whenever i click home x on repitier host the motor turns in forward direction not reverse, and motor does not turn complete it takes on 5-10mm steps. dont know what is wrong with it
any help will be highly appreciated and i'm new to this
i'm using these endstops
[www.amazon.in]
Got them working. deleting it.
Edited 3 time(s). Last edit at 04/02/2017 10:11AM by rohit939.
Sorry, only registered users may post in this forum.