repetier gcode for auto leveling

Hi guys,


I installed a inductive sensor on my prusa i3 and megatronics v3.
The probe is working fine, the command g29/g32 is working fine.

But i cant find much info about what gcode commands should be used when starting a print.

I tried

G28 ; y0 x0 z0
G29 ( also tried g32)

The printer homes and probes, but the z axis goes really high before each probe.
When the printing starts it prints really high above the printbed and the z rods are not turning while printing.

Can anyone give me some info or a link?

Thanks

Edited 1 time(s). Last edit at 01/03/2016 12:21PM by Govahnator.

What is the current setting on the Z axis Polulu? Sounds like it is set too low.

Thanks for the reply,

I am not sure what you mean with current setting on the polulu, do you mean the voltage?
I managed to fix the gcode issue (so the issues in my first post are resolved)
However when the print starts the nozzle is a few mm to high from the bed, i cant find the setting to change this .

I have to mention that before installing this auto leveling, my prints also started higher than i placed my z endstop ( i had to pretty much crash my nozzle in the bed when homing so it would be at the good hight when the printed started)

Thanks for the help

ps: i tried to remove the other thread, but i dont think it's possible.

Edited 3 time(s). Last edit at 01/04/2016 09:18PM by Govahnator.

I am thinking the problem might be that i am using the probe on z min :/

I have had to max my polulu settings on my drivers. If you google Polulu current adjustment the reprap link will show.
I have a Replikeo Prusa i3, sainsmart controller.

Can you explain why you think the current of the drivers has anything to do with this?
I really dont see what u mean.

I found that when I turned up my drivers the chattering and skipped motion of my x axis went away. The z axis duals weren't keeping in synch. That went away also.

Thanks for replying to my posts Giantkiller,

I changed to marlin firmware, and it fixed the issue.
Auto leveling is working perfect now.
my prints seem smoother to

Cheers

Cool. What software were you using before Marlin?