Welcome!
Log In
Create A New Profile
Home
>
Reprappers
> Topic
Advanced
Hictop 3DP11 - Anyone have the Firmware? Board "MKS Base v1.4"
Posted by
printingandprinting
Forum List
Message List
New Topic
printingandprinting
Hictop 3DP11 - Anyone have the Firmware? Board "MKS Base v1.4"
January 01, 2016 05:13AM
Registered: 8 years ago
Posts: 20
Their tech support is unresponsive...this is the printer I'm talking about; it uses the MKS Base v1.4 board:
[
www.amazon.com
]
Reply
Quote
Mike_C
Re: Hictop 3DP11 - Anyone have the Firmware? Board "MKS Base v1.4"
January 03, 2016 12:24AM
Registered: 8 years ago
Posts: 8
Its on the wiki, very bottom of the page. You will need to download arduino in order to flash it.
[
reprap.org
]
Reply
Quote
tgjohanson
Re: Hictop 3DP11 - Part ID
February 22, 2016 10:44PM
Registered: 8 years ago
Posts: 2
Hi,
I have a missing part that is circled in the following picture. Can someone ID this part?
Reply
Quote
Attachments:
open
|
download
- 3DP11 needed part.png (109 KB)
Bobyni
Re: Hictop 3DP11 - Anyone have the Firmware? Board "MKS Base v1.4"
February 22, 2016 10:47PM
Registered: 9 years ago
Posts: 221
Endstop
Microswitch
Reply
Quote
tgjohanson
Re: Hictop 3DP11 - Anyone have the Firmware? Board "MKS Base v1.4"
February 27, 2016 11:12PM
Registered: 8 years ago
Posts: 2
Thanks for your help. The Instruction manual also indicates the same though when I contact the manufacturer about the endstop they reply with a photo of the white ribbon cable with four ends..
Reply
Quote
Newer Topic
Older Topic
Print View
RSS
Sorry, only registered users may post in this forum.
Click here to login