Welcome! Log In Create A New Profile

Hictop 3DP11 - Anyone have the Firmware? Board "MKS Base v1.4"

printingandprinting

Hictop 3DP11 - Anyone have the Firmware? Board "MKS Base v1.4"
January 01, 2016 05:13AM

Registered: 8 years ago
Posts: 20

Their tech support is unresponsive...this is the printer I'm talking about; it uses the MKS Base v1.4 board:
[www.amazon.com]

Reply Quote

Mike_C

Re: Hictop 3DP11 - Anyone have the Firmware? Board "MKS Base v1.4"
January 03, 2016 12:24AM

Registered: 8 years ago
Posts: 8

Its on the wiki, very bottom of the page. You will need to download arduino in order to flash it.

[reprap.org]

Reply Quote

tgjohanson

Re: Hictop 3DP11 - Part ID
February 22, 2016 10:44PM

Registered: 8 years ago
Posts: 2

Hi,
I have a missing part that is circled in the following picture. Can someone ID this part?

Reply Quote

Attachments:
open | download - 3DP11 needed part.png (109 KB)

Bobyni

Re: Hictop 3DP11 - Anyone have the Firmware? Board "MKS Base v1.4"
February 22, 2016 10:47PM

Registered: 9 years ago
Posts: 221

Endstop
Microswitch

Reply Quote

tgjohanson

Re: Hictop 3DP11 - Anyone have the Firmware? Board "MKS Base v1.4"
February 27, 2016 11:12PM

Registered: 8 years ago
Posts: 2

Thanks for your help. The Instruction manual also indicates the same though when I contact the manufacturer about the endstop they reply with a photo of the white ribbon cable with four ends..