Solved it myself, turns out one of the end stops had disconeccted
Hey,
So I set up my new smart rap that I built, it's running Ramps 1.4 with Marlin. I connected to it with pronterface to check that everything is working, and I'm running into a wierd issue.
I can move all the axis and they move in the directions I want perfectly. But if I try home it, the Z and Y axis home fine
, but the X axis will just move about 1cm in the wrong direction from where it should be going then stop.
I have checked all my endstop settings in Marlin, and the Axis moves in the correct direction if I'm just jogging it, so this really has me stumped. If I press the end stop with my finger it works fine too.
If I restart pronterface, I can get it to move the X axis the correct way when homing a few cm, but then it just reverses and goes back to doing 1cm in the wrong direction.
Do you guys have any ideas?
Edited 1 time(s). Last edit at 12/18/2015 06:09AM by Brisbanefishman.