Welcome! Log In Create A New Profile

is it connection problem (control board)plzz help me

Posted by sallop

sallop

is it connection problem (control board)plzz help me
November 10, 2015 06:32AM

Registered: 8 years ago
Posts: 11

my connection for Y Axis stepping motor is not working properly whatever motor i connceted on that red circle connector it only move in one direction.
plz give me suggection

Reply Quote

Attachments:
open | download - zonestar.jpg (361.2 KB)

Bobyni

Re: is it connection problem (control board)plzz help me
November 14, 2015 02:02AM

Registered: 9 years ago
Posts: 221

turn upside down your board, to check if cold soldering;
check the male connector if the 4 pins are there

contact the seller to sent you the firmware and to flush it again and see if that rectifys

good luck