Aurora Z605 Thermistor Temperature Table October 04, 2015 08:48AM |
Registered: 9 years ago Posts: 23 |
Re: Aurora Z605 Thermistor Temperature Table October 04, 2015 09:26AM |
Registered: 8 years ago Posts: 197 |
Quote
fatalelieberi
Hi Reprappers,
I've just recently upgraded my Aurora Z605 3D printer. The default Melzi board is replaced by RAMPS 1.4. Now, I'm stuck in setting the firmware. I'm using Repetier firmware and now I can't decide what temperature table should be used for the extruder and heat bed thermistors. The currently applied setting, 100k Epcos B57560G0107F000, has higher reading, about 8C. Do you have any suggestion?
Thanks in advance.
Re: Aurora Z605 Thermistor Temperature Table October 06, 2015 12:31AM |
Registered: 9 years ago Posts: 23 |
Re: Aurora Z605 Thermistor Temperature Table October 07, 2015 01:49PM |
Registered: 8 years ago Posts: 197 |
Quote
fatalelieberi
Hi xile6,
I've tried that setting and all other preset value provided from the Repetier Online Configuration tool. None of them is accurate. In room temperature, each is correct, only has some minor deviation +-1C. But, as it gets hotter, the deviation became so big, about 20C. Maybe I'll have to create my own temperature table.
Re: Aurora Z605 Thermistor Temperature Table October 24, 2015 01:01AM |
Registered: 9 years ago Posts: 23 |
Re: Aurora Z605 Thermistor Temperature Table November 22, 2015 01:16AM |
Registered: 9 years ago Posts: 23 |