basically it gives me a reading between 8-250 unless the paper is right under the sensor then its like 920 so trying to calibrate the z home dosent work because its not enough of a difference in the readings and if i try to home x near the build plate it dosent work either. i tried lining the little sensor area with black tape but it made a small difference if any the sensor isnt toast because i can get a reading over 900 if the paper is touching the sensor .. any ideas?
i have a omerod 2 by repliko
Edited 2 time(s). Last edit at 07/26/2015 06:27PM by andrewfed.