Hi,
I've a issue with my reprap : everything is ok until I want to heat my heated bed, the printer instantly shuts down. There is no short, because as you can see i have directly plug the resistor on the Ramps to make sure there is no shorts. but it's the same.
To be more clear, I've recorded it : [
youtu.be]
Here the caracteristics of my ATX
Any ideas ? I've already changer my RAMPS so that's not the problem...
Thanks and have a great day
Simon
Edited 1 time(s). Last edit at 07/04/2015 10:56AM by Sim0-n.