PLA x-carriage yes or no? July 03, 2015 08:54PM |
Registered: 8 years ago Posts: 197 |
Re: PLA x-carriage yes or no? July 04, 2015 01:09AM |
Registered: 9 years ago Posts: 351 |
Re: PLA x-carriage yes or no? July 04, 2015 01:43AM |
Registered: 9 years ago Posts: 705 |
Re: PLA x-carriage yes or no? July 04, 2015 10:27AM |
Registered: 8 years ago Posts: 197 |
olQuote
IMBoring25
If you're just going to work in PLA (and even some ABS), a PLA x-carriage is well-precedented. If you were going to try your hand at higher-temperature materials I'd probably tell you to keep trying with the ABS.
Re: PLA x-carriage yes or no? July 04, 2015 10:38AM |
Registered: 8 years ago Posts: 197 |
Yours looks different from mines.Quote
elwood127
I just redesigned and reprinted my entire three piece x carraige in abs. I was at 230c and 100c and used 20% infill with "Automatic" infill settings which uses the "Grid" pattern in Cura on my Z605. They came out pretty darn flat. Slic3r gave me some lifting problems. I'm using glass and Elmers purple glue stick. Good luck.
[attachment 57515 DSC00478.jpg]
Re: PLA x-carriage yes or no? July 04, 2015 08:48PM |
Registered: 9 years ago Posts: 705 |