Has anyone used 303 stainless for linear rods?
Posted by Embed
|
Re: Has anyone used 303 stainless for linear rods? May 17, 2015 01:39AM |
These look like very, very high quality rods to me. 10 rms micron finish is fabulous, not just good. 
One suggestion though: I recommend you order them cut to exactly the length you need. Sawing through these rods is not the easiest thing in the world...
Edited 1 time(s). Last edit at 05/17/2015 01:41AM by AndrewBCN.
One suggestion though: I recommend you order them cut to exactly the length you need. Sawing through these rods is not the easiest thing in the world...
Edited 1 time(s). Last edit at 05/17/2015 01:41AM by AndrewBCN.
Sorry, only registered users may post in this forum.