Hi, me again!
This printer hates me...
I'm ignoring the LCD issue for the moment & trying to get the printer printing.
I can heat the bed in pronterface manually
I can heat the hot end in pronterface manually
I can extrude filiment once the hot end is hot in pronterface manually
I have loaded up a test cube, told it to print & it gets stuck at line 8, which is...
M190 S65 ; wait for bed temperature to be reached
It's heating the bed, but not the hot end, Ive checked & there's no power being supplied to the hot end.
If I preheat the hot end & then run the print, it still gets stuck even though its at temperature.
Any ideas how to get past it?
it was sliced in slic3r
I've included the files in case I did something wrong.