ABS Tprint issues. Wavy? March 09, 2015 03:54AM |
Registered: 9 years ago Posts: 248 |
Re: ABS Tprint issues. Wavy? March 09, 2015 06:43AM |
Registered: 9 years ago Posts: 752 |
Re: ABS Tprint issues. Wavy? March 09, 2015 06:45AM |
Registered: 10 years ago Posts: 241 |
Re: ABS Tprint issues. Wavy? March 09, 2015 08:27AM |
Registered: 9 years ago Posts: 248 |
Re: ABS Tprint issues. Wavy? March 09, 2015 09:02AM |
Registered: 9 years ago Posts: 1,159 |
Quote
OO DURKE OO
It is warping slightly on the one corner. The rest of it seems to lay flat fine. What temps are you guys running at? anything different?
Right now to help with adhesion I am using masking tape with some white glue stick on it.
I have kapton tape but its hard to lay it flat its about 4 inches wide in a roll. Any tips?
My bed has some marring on it from early print runs where I was still figuring out bed leveling. But other than that its clean I use a 50/50 spray and my tape pusher to get a good clean bed. 50/50 is a step above wd40 and a stronger degreaser and greaser.
This test print had a brim on it but it peeled off of it slightly.
Re: ABS Tprint issues. Wavy? March 09, 2015 09:13AM |
Registered: 9 years ago Posts: 248 |
Re: ABS Tprint issues. Wavy? March 16, 2015 09:34PM |
Registered: 9 years ago Posts: 182 |
Re: ABS Tprint issues. Wavy? March 17, 2015 12:34AM |
Registered: 9 years ago Posts: 53 |
Re: ABS Tprint issues. Wavy? March 17, 2015 10:57AM |
Registered: 9 years ago Posts: 465 |
Re: ABS Tprint issues. Wavy? March 19, 2015 04:32PM |
Registered: 9 years ago Posts: 248 |
Re: ABS Tprint issues. Wavy? March 23, 2015 09:14PM |
Registered: 9 years ago Posts: 248 |
Re: ABS Tprint issues. Wavy? March 24, 2015 11:36AM |
Registered: 9 years ago Posts: 465 |
Re: ABS Tprint issues. Wavy? March 24, 2015 12:03PM |
Registered: 9 years ago Posts: 251 |