"Heater Decoupled" error message

I am using an aurora Prusa I3 with a Z605 MB running repetier FW.

Recently I had to replace the thermistor on the print/heating block. Since then I get heater decoupled error messages and my bed/print head wont heat right.

What can I do?

this is the thermistor I am using

[www.amazon.com]

and This is my printer

[www.amazon.com]

Sounds like a problem with your connectors, get some new board connectors and rewire or solder Also is the thermostat the same as previous or do you need to change firmware???

Edited 1 time(s). Last edit at 02/11/2015 09:58AM by Chaser30.

could be this printer has caused me way to many issues. It was horrible from the start. So I bought a new CTC printer to replace it. that one is enclosed. Thanks for the help guys but after 2 weeks of nothing but issues and not even being able to have 1 successful print I've given up on this printer.

Maybe it was just a bad kit to begin with as its a chinese knock off I3.