So, I'm planning on building a p3steel equipped with two Mk V-BV J-head hot ends (0.40mmx1.75mm). Would anyone have any recommendations for what power supply I should use (what model)? Also, I was planning on buying a heatbed from tridprinting — [
www.tridprinting.com] — but, apparently, the current of the heatbed is supposed to be based off of the power supply used and what current/voltage it has. So, along with the power supply recommendations, I could also use a recommendation for the current of the heatbed (the current options are listed on the tridprinting page from the link above). Though, if anyone has a recommendation for a heatbed from a different site, I'll gladly look into it. Also, I'd rather a heatbed with a higher current, as that is apparently better for 3d printing, so I'd prefer a power supply that can accommodate a heatbed with a higher current. Thanks!
