Hi.
I finished building REPLIKEO Prusa i3 rework kit.
but I have a problem with its firmware.
I got a configuratio.h file at REPLIKEO web page below.
[
www.replikeo.com]
but it did not work because of error.
the config.h file was not compiled.the compiling process was stoped everytime because of error.
so...
Could Anyone upload a updated Marlin configuration.h file for me?
I am new to programing...so it is hard to re-write the configuration.h file.
if anyone could post the updated file, I would be happy.
My kit is
REPLILEO Prusa i3 rework
[
www.replikeo.com]
filament diameter is 1.75mm.
Ardoino software version is 1.0.6
Thanks!