Hi - can anyone see what is happening here? (pls see pic) The RepRap X axis is kicking out in the same place when moving right. Cant decide if its software or hardware. I dont think its the motor because it doesn't repeat across the print. Its worst on the first layer when it prints the little kick and then returns and threatens to foul on the wonky bit.
This video on
YouTube might help describe it better!
Any comments welcome - cheers :-)
Edited 1 time(s). Last edit at 10/28/2014 05:43PM by spezzer.
Attachments:
open |
download -
IMG_20141028_203038b.jpg
(210 KB)