Hello,
I'm thinking about adding my kossel mini another extruder. [I want the additional extruder to print parts that need support, colors is nice but not the issue]
In this
link someone has built one.
As expected he reported that the nozzles are very difficult to align to the same height.
Is there a solution to that issue besides less than ZERO diff in the nuzzles height?
Does anyone knows about a working version?
Does someone has some experience with things like the
ultimaker dual extruder?
[I was thinking about changing firmware to give 0.1-0.5 mm height for the not activated nuzzle but that would change the angle of the activated nuzzle touches the printed parts & I don't really sure how bad the results will be]
Edited 4 time(s). Last edit at 10/12/2014 03:42AM by polkary.
