Quote
txals
Hi guys,
I'm building a Prusa i3. With pronterface, every axis moves correctly. When I try to print the test part "0.5mm-thin-wall.stl", after having the 3 axis going home, it start moving to the center and then pronterface gets stuck on line 11 (of the gcode file I suppose) and goes off saying "segment violation" on the console.
Any idea?
Here is exactly what it says:
Slicing /home/txals/ScaD/0.5mm-thin-wall.stl
Running /home/txals/Prusa/Software/Slic3r/bin/slic3r /home/txals/ScaD/0.5mm-thin-wall.stl --load /home/txals/Prusa/Software/Printrun-master/config.ini --output /home/txals/ScaD/0.5mm-thin-wall_export.gcode
=> Processing triangulated mesh
=> Generating perimeters
=> Preparing infill
=> Infilling layers
=> Generating skirt/brim
=> Exporting G-code to /home/txals/ScaD/0.5mm-thin-wall_export.gcode
Done. Process took 0 minutes and 3.691 seconds
Filament required: 67.4mm (0.5cm3)
Loaded /home/txals/ScaD/0.5mm-thin-wall_export.gcode, 1294 lines
67.39mm of filament used in this print
The print goes:
- from 81.86 mm to 118.14 mm in X and is 36.29 mm wide
- from 81.86 mm to 118.14 mm in Y and is 36.29 mm deep
- from 0.00 mm to 10.10 mm in Z and is 10.10 mm high
Estimated duration: 25 layers, 0:03:46
Print started at: 19:54:02
ViolaciĆ³n de segmento
...pronterface goes off.