heatbed (yes mine doesn't work as well) August 06, 2014 07:12PM |
Registered: 9 years ago Posts: 50 |
Re: heatbed (yes mine doesn't work as well) August 06, 2014 08:27PM |
Registered: 11 years ago Posts: 1,592 |
Re: heatbed (yes mine doesn't work as well) August 07, 2014 02:09AM |
Registered: 9 years ago Posts: 50 |
Re: heatbed (yes mine doesn't work as well) August 07, 2014 04:05AM |
Registered: 11 years ago Posts: 1,592 |
Re: heatbed (yes mine doesn't work as well) August 07, 2014 04:29AM |
Registered: 9 years ago Posts: 50 |
Re: heatbed (yes mine doesn't work as well) August 08, 2014 06:16AM |
Registered: 9 years ago Posts: 50 |
Re: heatbed (yes mine doesn't work as well) August 08, 2014 07:46AM |
Registered: 11 years ago Posts: 1,592 |
Re: heatbed (yes mine doesn't work as well) August 14, 2014 10:40AM |
Registered: 10 years ago Posts: 553 |
Quote
polkary
waitaki Thank you!
following your guide lines I've resolved the issue.
I've moved to the official delta.
I'm not sure it is a bug since I've just began to learn the firmware but although I've selected #define MOTHERBOARD 33
This DIDN'T ENFORCED the "TEMP_SENSOR_BED" to be 1 on the configuration file hence has you mentioned it wasn't active.
(is there a reason for that since " 33 = RAMPS 1.3 / 1.4 (Power outputs: Extruder, Fan, Bed)" made me think that fan & bed & extruder will be activated.. )
Now that it's working I noticed huge delay from the moment I tell the bed to be activated till the moment the light is on (about 3-4 seconds) compering to hot end which turns on immediately.
Is this behavior is OK?
Re: heatbed (yes mine doesn't work as well) August 15, 2014 04:56AM |
Registered: 9 years ago Posts: 50 |
Re: heatbed (yes mine doesn't work as well) August 15, 2014 07:21AM |
Registered: 10 years ago Posts: 553 |
Quote
polkary
Thank you.
Could you kindly explain to me why there are(from configuration.h):
// 33 = RAMPS 1.3 / 1.4 (Power outputs: Extruder, Fan, Bed)
// 34 = RAMPS 1.3 / 1.4 (Power outputs: Extruder0, Extruder1, Bed)
// 35 = RAMPS 1.3 / 1.4 (Power outputs: Extruder, Fan, Fan)
If I understand correctly I could have set my board to 33/34/35 right? as long as I set the outputs of extruder,fan,bed etc' correctly..
Re: heatbed (yes mine doesn't work as well) August 17, 2014 06:11AM |
Registered: 9 years ago Posts: 50 |