Hello world!
My arduino mega2560 had a problem it can't hold serial communications anymore....
I had an external ft232 so serial communication works again. but since i can't print cause i got the error:
Printer stopped due to errors. Fix the error and use M999
this error only appears when I try to move a motor... I can check temp and heat without any problem.
I was wondering if it could be related....
I read that this error show up when thermistor has an issue, but mine work fine, at least the host soft shows the right temp, even when i heat.
Pronterface show the error, but i have the same problem with cura, only it doesn't have any terminal to show what's the problem, so it just freeze.
So any ideas?