I'm having problems controlling the second hot end on my Azteeg X3 pro. Has anyone else used this board or other RAMPS boards to control two hot ends? If so I need some advice. The first extruder heats with no problems and I can extrude no problem. The second extruder has been nothing but problems. When I turn the heat on in Proterface the first one heats to 240°C in less than 10 seconds, when I set the second heater, I can see it dimly blink the heater LED but it would take several hours to gain 10-20°C. How can I change the way the second heater ramps the power? I can't seem to find it in the Config.H or the Config_adv.H
Edited 2 time(s). Last edit at 05/31/2014 12:37AM by Schultz.