On my first print the y axis started to slowly go over has the print went on and then it started to go back in the opposite direction until the print was over but on the next print I printed after the first layer it I thought it jump over so I slowed the printer down and turn down the current and then I printed a different piece and I saw that it wasn't jumping but has it was generating the first layer the print would slowly get shorter and then on the second layer it would reposition itself and start printing slightly offset and after that the print would slowly move over but on this print instead off going back over it started going straight up until the hotend stoped extruding which I am trying to address in another furom. I don't Think it is calibration because I have it generating a honeycomb for the middle and that looks fine. If you have any suggestions please comment thanks.
