Welcome! Log In Create A New Profile

Advanced

New to 3d printing

Posted by jwver 
Forum List Message List New Topic
jwver
New to 3d printing
September 24, 2013 09:18PM
I have been doing a lot of research on diy 3d printers and was wondering what is the easiest reprap build for a beginning project
Reply Quote
conscripted
Re: New to 3d printing
September 25, 2013 11:39AM
There are some many different options that you are going to get many different answers to your question.

Are you looking for a kit or to source all the parts for your printer?

What is your budget?

Kits will be easier to build but may cost a little more.

Conscripted
Reply Quote
jwver
Re: New to 3d printing
September 25, 2013 08:30PM
i was looking to get the parts myself as long as i can get the printed parts i need, and i would rather keep it cheat
Reply Quote
jwver
Re: New to 3d printing
September 25, 2013 08:57PM
cheap*
Reply Quote
McSquid
Re: New to 3d printing
September 26, 2013 05:31PM
Having just started myself I opted for a Prusa i3. My parts cost came to $432 (just ordered last night). Some people reccomended the i2 due to better documentaion and apparently its easier to find kits. Id offer you my parts list but until I know its complete and has no problems im going to keep it to myself to avoid causing other people problems
Reply Quote
jwver
Re: New to 3d printing
September 30, 2013 08:17PM
thaNks a lot im going to check out the pursa
Reply Quote
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login