I know, it sounds like a firmware question, but it's related to CoreXY.
I've installed an inductive Z-probe and it works as z-endstop and z-probe as well.
I had a hard time to find uptodate information about RRF and bed leveling.
G32 is a dead end?
Wiki says: M557 is deprecated in RRF and to use bed.g instead.
But what would bed.g look like?
On escher3d.com is a bed-file generator for deltas only.
Do I have to specify a giant list of M557 probe points or can I use
M557 X0:300 Y0:200 S40??
Should I use G29 instead?
It sounds like the right way, but does it work for non_delta printers?
Also in G29 wiki there's no word about bed.g, it is about M557...