I built the D-bot from
[
www.thingiverse.com]
Works great. Recently I added a proximity sensory or Auto Level also works. However when I home the Z it will not move to the center of the bed. It will home in the back left corner of the bot. Now If I swap the X and Y motors and switch Y to a min stop versus a Max stop. It will home in the center of the bed no problem Buit all my prints are facing backwards( not the end of the world just annoying)
I would prefer to put it back the way it is stock and have Y be my max again. Then get it to safe home like this but I can't seem to find anything on it. Can anyone help me?
Here is my config file
[
pastebin.com]
Any help would be great