I'm stuck configuring my COREXY end stops October 05, 2014 12:21AM |
Registered: 10 years ago Posts: 80 |
Re: I'm stuck configuring my COREXY end stops October 05, 2014 02:19AM |
Admin Registered: 13 years ago Posts: 7,008 |
Re: I'm stuck configuring my COREXY end stops October 05, 2014 02:29AM |
Registered: 10 years ago Posts: 14 |
Re: I'm stuck configuring my COREXY end stops October 05, 2014 06:56AM |
Registered: 9 years ago Posts: 26 |
Quote
Draob
With coreXY the belts cross over at the back.
I don't see this with your setup, don't know if that is o.k. (No experience with these kinds of setups)
Re: I'm stuck configuring my COREXY end stops October 05, 2014 07:31AM |
Registered: 10 years ago Posts: 80 |
Re: I'm stuck configuring my COREXY end stops October 06, 2014 11:47PM |
Registered: 9 years ago Posts: 42 |
Re: I'm stuck configuring my COREXY end stops October 07, 2014 04:23PM |
Registered: 10 years ago Posts: 80 |
Re: I'm stuck configuring my COREXY end stops October 16, 2014 10:30PM |
Registered: 10 years ago Posts: 80 |
Re: I'm stuck configuring my COREXY end stops October 18, 2014 01:53PM |
Admin Registered: 11 years ago Posts: 3,096 |
Quote
gadittri
Update!
I ended up having to reverse my XY like Polyglot suggested after trying to print the attached STL today. For some reason the X was printing mirrored even though the Kisslicer and Repetier showed the object correctly on the monitor. Anyway, thought I would share for lessons learned for others.
Thanks,
Greg