Welcome! Log In Create A New Profile

SmartCore Z issues

Posted by jbutj

jbutj

SmartCore Z issues
May 31, 2015 03:26PM

Registered: 9 years ago
Posts: 68

Hi Im building a smartcore. My bed has been giving ,me some issues. It was moving up and down at the correct speed but now suddenly started to move at super high speeds and is moving to far up/down. When i move it to another motor pin it moves fine, Heres what i have tired so far

- New board
- Checked the micro stepping pins
- Reflashed the firmware

Any ideas ?

Reply Quote

smartfriendz

Re: SmartCore Z issues
May 31, 2015 03:58PM

Registered: 10 years ago
Posts: 992

What a weird problem . Each time i had this problem was because i had an old Z setting from the smartrap , with a screw , running at 7000 steps/mm . Maybe you could check the firmware if you have a old setting still running ?

the best is to reset the memory with a M502 ( reload default factory settings).

the Smartrap project

[smartfriendz.com]
[www.thingiverse.com]
[reprap.org]
[github.com]
doc assemblage: [reprap.org]
NEW: Forum smartfriendz: [smartraptalk.smartfriendz.com]

Reply Quote

jbutj

Re: SmartCore Z issues
May 31, 2015 04:08PM

Registered: 9 years ago
Posts: 68

Thanks for the reply. So i ran that command and it just makes the movement really slow

I have downloaded the firmware from github so its defo the right one

Reply Quote

jbutj

Re: SmartCore Z issues
May 31, 2015 04:12PM

Registered: 9 years ago
Posts: 68

Correction - Running that command sorts the issue but when i unpower the printer it goes back to normal sad smiley

Reply Quote

smartfriendz

Re: SmartCore Z issues
May 31, 2015 05:07PM

Registered: 10 years ago
Posts: 992

Ho.. I forgot :

You need to do an M502 ( load defaut ) AND an M500 again to store again those default values !

at least, it seems that the problem was this one ( old eeprom values ). I remember loosing hours on that smiling smiley

the Smartrap project

[smartfriendz.com]
[www.thingiverse.com]
[reprap.org]
[github.com]
doc assemblage: [reprap.org]
NEW: Forum smartfriendz: [smartraptalk.smartfriendz.com]