Hello!
I have upgraded my Ormerod 1 with a new Duet 0.85 and installed the firmware v. 1.09. The SD card got the files from the same downloadf as the firmware. I'm using the sys-Ormerod-1 files.
The web-interface is working.
All motors are connected the same way.
X-movements are correct and X-homing works.
Z-movements are opposite was it should be, I can change the motors connection to solve this.
Y-movements are in the wrong direction, BUT when homing the Y the bed goes in the right direction but don't recognize the end switch. There is a red LED that lights up when the end switch is activated.
E motor don't work. I did heated the nozzle to 170C but it still didn't work.
Bed don't heat up and shows a temperature of 50C when it is cold. (I have no extra resistors in series with the thermistors.)
Do anyone have any suggestions for fixing my Ormerod?
Ormerod #399 and He3D K200 dual head.