extending the heating-up time

hi community

i wondered if it was possible to extend the time the heater has before the software stops heating
and posts and error.

The Issue i have: because of different surrounding temperatures the heater takes sometimes
about 10sec longer than usual then the software posts an error to me:

G10 P1 S204
Heating fault on heater 1, T = 197.5 C; still not at temperature 204.0 after 150.220276 seconds.

so i want to to extend the ~150.220276 up to 200 seconds is there a gcode for it?



Firmware Version: 1.09k-dc42 (2015-09-20)
Web Interface Version: HTML: 1.06, JS: 1.06

Yes, see [reprap.org].

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

as always dc42 solved it
thank you very much