hi community
i wondered if it was possible to extend the time the heater has before the software stops heating
and posts and error.
The Issue i have: because of different surrounding temperatures the heater takes sometimes
about 10sec longer than usual then the software posts an error to me:
G10 P1 S204
Heating fault on heater 1, T = 197.5 C; still not at temperature 204.0 after 150.220276 seconds.
so i want to to extend the ~150.220276 up to 200 seconds is there a gcode for it?
Firmware Version: 1.09k-dc42 (2015-09-20)
Web Interface Version: HTML: 1.06, JS: 1.06