Welcome! Log In Create A New Profile

Advanced

extending the heating-up time

Posted by redblunt 
extending the heating-up time
May 10, 2017 11:22AM
hi community

i wondered if it was possible to extend the time the heater has before the software stops heating
and posts and error.

The Issue i have: because of different surrounding temperatures the heater takes sometimes
about 10sec longer than usual then the software posts an error to me:

G10 P1 S204
Heating fault on heater 1, T = 197.5 C; still not at temperature 204.0 after 150.220276 seconds.

so i want to to extend the ~150.220276 up to 200 seconds is there a gcode for it?



Firmware Version: 1.09k-dc42 (2015-09-20)
Web Interface Version: HTML: 1.06, JS: 1.06
Re: extending the heating-up time
May 10, 2017 01:41PM
Yes, see [reprap.org].


Delta printer calibration calculator, mini IR Z probe, and colour touch screen control panel: [escher3d.com]

Large delta printer, and other 3D printer blog postings: [miscsolutions.wordpress.com]

Full disclosure: I have a financial interest in sales of the Panel Due, Mini IR height sensor, and Duet WiFi/Duet Ethernet.
Re: extending the heating-up time
May 10, 2017 02:51PM
as always dc42 solved it
thank you very much
Sorry, only registered users may post in this forum.

Click here to login