Hi all,
It has been quite some time since I used my Ormerod v1.
I intend on using the latest DC42 firmware (I have used it previously, but that was a long time ago and a lot has probably changed since then) and probably SD-card image (as the current one I have will be way too old I imagine).
Is there a document or post containing configuration and setup/startup changes that differ from reprap documents for the Ormerod v1 when using DC42's firmware?
My memory probably will fail me and I would like to start using this printer again really soon (I have some upgrades etc that I need to install tonight and I will be setting the printer up from scratch).
I am using DC42's sensor board also.
Any guidance with this would be greatly appreciated.
Thanks,
Dan
Edited 1 time(s). Last edit at 10/06/2016 07:51PM by DanV.
