ormerod firmware 078c August 17, 2016 03:31AM |
Registered: 9 years ago Posts: 7 |
Re: ormerod firmware 078c August 17, 2016 05:13AM |
Registered: 9 years ago Posts: 7 |
Re: ormerod firmware 078c August 17, 2016 05:27AM |
Registered: 9 years ago Posts: 638 |
Re: ormerod firmware 078c August 17, 2016 05:41AM |
Registered: 9 years ago Posts: 7 |
Re: ormerod firmware 078c August 17, 2016 05:46AM |
Registered: 9 years ago Posts: 7 |
Quote
Darathy
either you have a bad SD card or an Empty Card. Try following this guide: [reprappro.com]
or [reprappro.com] for ormerod 1
Re: ormerod firmware 078c August 17, 2016 08:11AM |
Registered: 10 years ago Posts: 14,672 |
Re: ormerod firmware 078c August 17, 2016 11:42PM |
Registered: 9 years ago Posts: 7 |
Quote
dc42
I suggest you download and install a precompiled binary again and see if it can read your SD card. If so then there is probably something wrong with your compilation process.
Bear in minds that the RepRapPro release of RRF is no longer supported and hasn't been updated since April 2015. Most people use my fork or Chrishamm's fork these days.
Re: ormerod firmware 078c August 18, 2016 05:16AM |
Registered: 10 years ago Posts: 14,672 |
Quote
ormerod2004
i download the code from here [github.com]
is the project your fork or Chrishamm's fork ?
Quote
which board should i choose?
should I used the hardware from the project i download ?
Re: ormerod firmware 078c August 18, 2016 06:00AM |
Registered: 9 years ago Posts: 7 |
Quote
dc42
Quote
ormerod2004
i download the code from here [github.com]
is the project your fork or Chrishamm's fork ?
That's old RRP release.
My fork: [github.com]
Chrishamm's fork: [github.com]
You may have to make some changes to other parts of the system when using more recent firmware, specifically:
1. Upgrade the /www files on the SD card to the compatible version of DuetWebControl (1.11 for my fork)
2. Add a M574 line to config.g to tell the firmware where your homing switches are (necessary for an Ormerod 1, optional for an Ormerod 2)
3. Make sure the X motor connector is the same way round as all the other connectors, or the X axis may move backwards.
4. If connecting to a Windows host computer via USB, install the device driver files at [github.com].
You may also wish to update the homeall.g file to do simultaneous X and Y homing.
Quote
which board should i choose?
should I used the hardware from the project i download ?
Pleas explain what you mean.