You could of course use several nested (? operators, but the code would become long and difficult to read...
A recursive function like the lookup() function below is probably easier and can be used for as many value pairs as needed:
function lookup(v,var,lar,i=0) = (var[ i ]==v) ? lar[ i ] : ( i < len ( var ) ? lookup( v, var, lar, i + 1 ) : -1);
fanmount_dist = lookup(fan_width, [40,50,60,80], [32,40,02,70]);
Note that if the given fan_width value is not found, lookup() will return the value -1.
Edited 7 time(s). Last edit at 12/09/2016 11:17PM by enif.
thank you very much, just what I'm looking for.
I think I might be doing something wrong because I can not get your code to work.
There seems to be an extra ")" on the last line and when I remove it the code compiles but no matter what I set fan_width to I only get -1 returned
So I am stumped, it's probably easily rectified but I just don't have the skills to spot the error.
appjaws - Ormerod 1, core XYUV Duet wifi, duex5
firmware 1.20.1RC2 Web Server 1.20+1 Web Interface 1.20
OpenSCAD version 2016.02.09 (git 9950e6a)
slic3r-1.38.5-prusa3d and/or Simplify3D 4.0.0
Ok, I found the problem: The forum software "mangled" the program lines. I knew that this happens sometimes in code section by adding unwanted smileys, but this time it ate up the indices and the square brackets of the lar and var arrays. In the edit window and even in the preview window all shows correctly, but then one submitted, the message gets mangled. So I had to do a lot of trial an error editing added unneeded blanks until I finally found a way which seems to show up correctly in the message thread... Let's hope it now works for you.