Welcome! Log In Create A New Profile

Advanced

Super dumb question: any difference in printed parts from regular to sturdy?

Posted by jswilson64 
Super dumb question: any difference in printed parts from regular to sturdy?
June 07, 2017 11:22AM
Subject pretty much has it.

Aside from obvious (10mm vs 8mm rods, etc) is there any difference in printed parts between the "sturdy" version and the "regular" Mendel 90? Like the fixing blocks, motor brackets, etc?
Re: Super dumb question: any difference in printed parts from regular to sturdy?
June 09, 2017 10:58AM
Nearly all the parts are different because they use wood screws into the MDF frame instead of nuts and bolts. A few bits like the extruder parts are the same.


[www.hydraraptor.blogspot.com]
Sorry, only registered users may post in this forum.

Click here to login