Welcome! Log In Create A New Profile

Anyone else using Simplify3d

danlad1631

Anyone else using Simplify3d
April 10, 2016 05:52AM

Registered: 11 years ago
Posts: 180

Just wondering if anyone else is using SImplify 3d? I've been using it for a while now.

What sort of results are you getting?

I've been getting great results on larger parts but not so great on smaller parts. On smaller parts I tend to get more blobs at the start/end points.

I've attached my FFF profile for anyone that is using S3D.

Thanks

Reply Quote

Attachments:
open | download - test settings.fff (11.2 KB)

alkempster

Re: Anyone else using Simplify3d
April 10, 2016 08:56AM

Registered: 8 years ago
Posts: 40

i am, great results so far. Just need to remember what all the options do now smiling smiley

Reply Quote

danlad1631

Re: Anyone else using Simplify3d
April 10, 2016 09:07AM

Registered: 11 years ago
Posts: 180

What are your start and end points like? Attached is an image of a print I've just done.

I can't seem to get this part of the print right.

Would you share your FFF settings?

Reply Quote

Attachments:
open | download - IMG_4628.jpg (491.7 KB)

alkempster

Re: Anyone else using Simplify3d
April 11, 2016 04:22PM

Registered: 8 years ago
Posts: 40

mine is similar, but not quite so noticeable, for some things i use the choose start point closest to point... as this allows aligning them to an edge, mostly i just stick to print what is fastest