Welcome! Log In Create A New Profile

Waiting time after reaching print temp

Posted by atmark

atmark

Waiting time after reaching print temp
November 07, 2015 02:37AM

Registered: 8 years ago
Posts: 96

Hey

Haven't found yet a place to tweak this. After reaching bed and hotend temperature Marlin always waits 60 sec. before it begins to print. I my oppinion it's a unnecessarily long time to stabilize the temp. I think 5-15 sec. would be enough.

In the config-file there seems to be no setting for this time. So where is it hiding? Has anyone an idea?

Reply Quote

nophead

Re: Waiting time after reaching print temp
November 07, 2015 05:42AM

Admin
Registered: 17 years ago
Posts: 7,879

It isn't waiting for the temperature to stabilise per se, it is waiting for the heat to to spread up the PEEK insulator so that it expands to its maximum length. If it is too small you get inconsistent first layer thickness.

It is defined as TEMP_RESIDENCY_TIME 60 in configuration.h

[www.hydraraptor.blogspot.com]

Reply Quote

atmark

Re: Waiting time after reaching print temp
November 08, 2015 03:17AM

Registered: 8 years ago
Posts: 96

Ok, I see. As I'm using the full metal e3d extruder it's propably safe to reduce the time.

Will do some tests.

Thanks again smiling smiley