SOLVED:Z Axis issues December 29, 2012 06:37AM |
Registered: 11 years ago Posts: 10 |
Re: X Axis issues December 29, 2012 07:52AM |
Registered: 11 years ago Posts: 29 |
Re: X Axis issues December 29, 2012 03:54PM |
Registered: 11 years ago Posts: 10 |
Re: Z Axis issues December 29, 2012 04:41PM |
Admin Registered: 17 years ago Posts: 7,879 |
Re: Z Axis issues December 29, 2012 08:49PM |
Registered: 11 years ago Posts: 10 |
Re: Z Axis issues December 30, 2012 07:03AM |
Admin Registered: 17 years ago Posts: 7,879 |
Re: Z Axis issues December 30, 2012 02:23PM |
Registered: 11 years ago Posts: 10 |
Re: SOLVED:Z Axis issues January 01, 2013 07:53PM |
Registered: 11 years ago Posts: 250 |
Re: SOLVED:Z Axis issues January 01, 2013 08:08PM |
Registered: 11 years ago Posts: 10 |
Re: SOLVED:Z Axis issues January 02, 2013 04:03AM |
Admin Registered: 17 years ago Posts: 7,879 |
Re: SOLVED:Z Axis issues January 02, 2013 12:33PM |
Registered: 11 years ago Posts: 250 |
Re: SOLVED:Z Axis issues January 02, 2013 03:58PM |
Admin Registered: 17 years ago Posts: 7,879 |
// ENDSTOP SETTINGS: // Sets direction of endstops when homing; 1=MAX, -1=MIN #define X_HOME_DIR -1 #define Y_HOME_DIR -1 #define Z_HOME_DIR 1 #define min_software_endstops true //If true, axis won't move to coordinates less than HOME_POS. #define max_software_endstops true //If true, axis won't move to coordinates greater than the defined lengths below. // Travel limits after homing #define X_MIN_POS -100 #define X_MAX_POS 100 #define Y_MIN_POS -100 #define Y_MAX_POS 100 #define Z_MIN_POS 0 #define Z_MAX_POS (Z_HOME_POS - 0.1) // The position of the homing switches. Use MAX_LENGTH * -0.5 if the center should be 0, 0, 0 #define X_HOME_POS (X_MIN_POS - 1) #define Y_HOME_POS (Y_MIN_POS - 1) #define Z_HOME_POS (203.0) #define X_MAX_LENGTH (X_MAX_POS - X_MIN_POS) #define Y_MAX_LENGTH (Y_MAX_POS - Y_MIN_POS) #define Z_MAX_LENGTH (Z_MAX_POS - Z_MIN_POS)
//homing hits the endstop, then retracts by this distance, before it tries to slowly bump again: #define X_HOME_RETRACT_MM 2 #define Y_HOME_RETRACT_MM 2 #define Z_HOME_RETRACT_MM 1 #define QUICK_HOME //if this is defined, if both x and y are to be homed, a diagonal move will be performed initially.
Re: SOLVED:Z Axis issues January 03, 2013 01:01AM |
Registered: 11 years ago Posts: 250 |
Re: SOLVED:Z Axis issues January 03, 2013 06:04AM |
Admin Registered: 17 years ago Posts: 7,879 |